Breech block extractor problem

G.T. · 08-29-2015, 08:31 PM

And I think that the barrel could be cut / set back one full turn, and at the same time cut (as large a radius as possible?) slightly forward as well? And then a spacer cut and pressed on to replicate the shoulder and flange area, and install and profiled same as the original concave radius and flange? It would be like a two part barrel?.... all it has to do is re-index correctly and tightly, and also have the extractor and feed ramp recut, and be re-chambered to close on the "GO"... I could accomplish that?

It wouldn't be perfect, but I bet it would work?.... Anyway, some better than .020" too deep on the breech end??...

.. Best to you, til...lat'r....GT .....

08-29-2015, 08:31 PM	#30
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,528 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	I have pondered this before! And I think that the barrel could be cut / set back one full turn, and at the same time cut (as large a radius as possible?) slightly forward as well? And then a spacer cut and pressed on to replicate the shoulder and flange area, and install and profiled same as the original concave radius and flange? It would be like a two part barrel?.... all it has to do is re-index correctly and tightly, and also have the extractor and feed ramp recut, and be re-chambered to close on the "GO"... I could accomplish that? It wouldn't be perfect, but I bet it would work?.... Anyway, some better than .020" too deep on the breech end??..... Best to you, til...lat'r....GT .....