Question Regarding Imperial Rod

[Norme]

Originally Posted by postino

OK, I need a little help here...Are you talking about the entire full length of the rod being soldered to the grease pot clamp??? Or just the stub that I can see the rod being inserted into??? Whether or not the brass rod is soldered or threaded into the stub...

Is the brass rod w/auger supposed to be removable???

I don't think I can understand this without looking at/inspecting one...

Hi Rich, I'm referring to the junction between the brass shaft and the steel handle. Without heating one of these up and dismantling, it's not possible to tell if the turned down end of the rod is threaded or not. Of course, that's assuming that the rod is male and the handle is female. The point is that the joint is designed to be permanent and non-rotational.
Regards, Norm