7.65mm Truncated bullet

[Sieger]

Originally Posted by G.T.

Hi Sieger & Ray.... count me in... I will split whatever cost amoung however many to get a custom mold like that... should be two of four cavity though... and have a small radius on the trunc top flat edge(just like the jcketed bullet)... like the RCBS for the 9mm TC mold, I'm in boys! til....lat'r....GT

Hi GT:

What about that Recoil Spring project?

Yes, the Lead RCBS 124 grain TC bullet is a very accurate bullet. This is my most accurate in the 9mm (properly handloaded, six touching on a regular basis at 25 yards).

Frankly, just downsizing that bullet design to 7.65 may be a good place to start a bullet design project. indeed!!! Remember, its the length of the bullet that really counts, not the weight (within reason).

Sieger