Luger Target Trigger Modification

03-09-2002, 06:22 PM

The method Hugh describes and trigger photos come from a May 1974 "Shooting Times" article pages 28,29 and 30 by Mike Gorman. The piece was directed at work on a 1970s Mauser. The methods work fine on other Lugers. I have refered to the article and reworked fireing pins for a number of years with good success. Polishing bearing surfaces as described in the article also helps a bit. The small screws in trig help. My experience has been--that adjusting the slack take up screw is a bit tricky. Remove too much slack and sear does not catch when fired even though it may work fine when action is worked by hand. Perhaps someone [maybe me] would scan the article and forward to seriously intersted guys.

03-09-2002, 06:22 PM	#3
Art Buchanan Guest Posts: n/a	Re: Long Trigger Pull The method Hugh describes and trigger photos come from a May 1974 "Shooting Times" article pages 28,29 and 30 by Mike Gorman. The piece was directed at work on a 1970s Mauser. The methods work fine on other Lugers. I have refered to the article and reworked fireing pins for a number of years with good success. Polishing bearing surfaces as described in the article also helps a bit. The small screws in trig help. My experience has been--that adjusting the slack take up screw is a bit tricky. Remove too much slack and sear does not catch when fired even though it may work fine when action is worked by hand. Perhaps someone [maybe me] would scan the article and forward to seriously intersted guys.