8" barrel source?

John Sabato · 01-30-2003, 02:18 PM

Hey Lonnie,

I can answer this one...the rear site dovetail on an artillery luger is physically part of the barrel... I don't know if they were machined from bar stock or were forged into that shape and drilled, but they are definitely not soldered on like a 98 Mauser rifle rear sight base usually is.

This closeup is of my "frankenartillery" luger rear sight base. You can see the whole pistol in the old Owner's Corner under my name... It is a parts gun made up of 1914 Erfurt parts.

The gouges you see in the rear sight base is where some amateur clamped it in a vise to attempt to remove the barrel from the upper receiver... fortunately for me, the previous owner did not damage anything else...

01-30-2003, 02:18 PM	#4
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,309 Times in 1,098 Posts	Hey Lonnie, I can answer this one...the rear site dovetail on an artillery luger is physically part of the barrel... I don't know if they were machined from bar stock or were forged into that shape and drilled, but they are definitely not soldered on like a 98 Mauser rifle rear sight base usually is. This closeup is of my "frankenartillery" luger rear sight base. You can see the whole pistol in the old Owner's Corner under my name... It is a parts gun made up of 1914 Erfurt parts. The gouges you see in the rear sight base is where some amateur clamped it in a vise to attempt to remove the barrel from the upper receiver... fortunately for me, the previous owner did not damage anything else... __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode