Mitchell Stainless Aimco repair

LarryT · 07-15-2004, 05:18 PM

Gentlemen,

Just received my 1993 Mitchell SS Luger from OFM Corp following repair of the trigger not re-setting. It appears that what they did was grind down the face of the top pad of the trigger lever a bit, then grinding away several thousandths of material just below the top pad of the trigger lever in order to allow the trigger bar stud to pass in front of the lever. The overall grinding area is 1/4 inch down from the top of the trigger lever. It resets just fine now.

LarryT

07-15-2004, 05:18 PM	#1
LarryT User Join Date: Jan 2003 Location: Indianapolis, Indiana Posts: 50 Thanks: 0 Thanked 0 Times in 0 Posts	Mitchell Stainless Aimco repair Gentlemen, Just received my 1993 Mitchell SS Luger from OFM Corp following repair of the trigger not re-setting. It appears that what they did was grind down the face of the top pad of the trigger lever a bit, then grinding away several thousandths of material just below the top pad of the trigger lever in order to allow the trigger bar stud to pass in front of the lever. The overall grinding area is 1/4 inch down from the top of the trigger lever. It resets just fine now. LarryT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode