1921 Police Grips

Dwight Gruber · 07-31-2003, 03:50 AM

HonestJon,

Check the left side of the gun. You should find a hole drilled into the left side of the frame, and a small cut visible center-bottom of the flat side panel. These are the modifications made to the steel for the magazine safety. If they are there, then the grip-cut is proper, even if the mag safety is gone.

Somebody here can probably post a picture of these modifications.

--Dwight

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-31-2003, 03:50 AM	#3
Dwight Gruber User Join Date: Jun 2002 Location: Portland, Oregon Posts: 3,908 Thanks: 0 Thanked 1,330 Times in 435 Posts	HonestJon, Check the left side of the gun. You should find a hole drilled into the left side of the frame, and a small cut visible center-bottom of the flat side panel. These are the modifications made to the steel for the magazine safety. If they are there, then the grip-cut is proper, even if the mag safety is gone. Somebody here can probably post a picture of these modifications. --Dwight