triggerproblems

Lugerdoc · 10-06-2003, 11:06 AM

Craig, I'd make sure that the sideplate is properly located in the frame groove to the rear of the sideplate first. If that doesn't cure the problem, then check the spring tention of the disconnector (plunger in the trigger bar). This is what pushes the diconnector under the trigger lever in the sideplate to make contact. Finally, you may have the increase the angle of at the top of the trigger lever, to allow the disconnector to push it out of the way when the trigger is released after each shot. TH

10-06-2003, 11:06 AM	#2
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	Craig, I'd make sure that the sideplate is properly located in the frame groove to the rear of the sideplate first. If that doesn't cure the problem, then check the spring tention of the disconnector (plunger in the trigger bar). This is what pushes the diconnector under the trigger lever in the sideplate to make contact. Finally, you may have the increase the angle of at the top of the trigger lever, to allow the disconnector to push it out of the way when the trigger is released after each shot. TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode