Temper of Mainspring Guide?

milesc2 · 08-15-2018, 11:22 AM

Well, I don't know how I could make this part out of a drill rod, but you have a much more advanced skill-set than me so i'm sure it would be simple for you to whip one up.

The whole idea with this new part is to have a better hook on the end than one formed by hand. GT helped me out by supplying a NOS Mauser or Swiss part that has more of a hook on the end when compared to an original part.

All in all this project should only cost me 20 bucks for the weld and a couple hours of my time.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-15-2018, 11:22 AM	#6
milesc2 User Join Date: Dec 2016 Location: Kansas City Posts: 214 Thanks: 328 Thanked 249 Times in 66 Posts	Well, I don't know how I could make this part out of a drill rod, but you have a much more advanced skill-set than me so i'm sure it would be simple for you to whip one up. The whole idea with this new part is to have a better hook on the end than one formed by hand. GT helped me out by supplying a NOS Mauser or Swiss part that has more of a hook on the end when compared to an original part. All in all this project should only cost me 20 bucks for the weld and a couple hours of my time.