"When opportunity knocks!!!"

G.T. · 03-15-2017, 10:02 PM

Hi Rick, hey, I value, and accept, your input without hesitation... you have that, " been there done that" experience that is impossible to get anywhere else.... If you say something, you can bet your butt, I'm listening!

I still have a lot to learn, and i'm not going to get there with out help from my forum friend / family! But, more important, using the .200" to .220" as a standard blade starting point... what would you recommend for increments...?? Good to hear from you Rick... best to all, til...lat'r...GT..

03-15-2017, 10:02 PM	#11
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,528 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	valued input..... Hi Rick, hey, I value, and accept, your input without hesitation... you have that, " been there done that" experience that is impossible to get anywhere else.... If you say something, you can bet your butt, I'm listening! I still have a lot to learn, and i'm not going to get there with out help from my forum friend / family! But, more important, using the .200" to .220" as a standard blade starting point... what would you recommend for increments...?? Good to hear from you Rick... best to all, til...lat'r...GT..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode