DWM Commerical breechblock question

saab-bob · 02-23-2015, 11:04 AM

Gents.
Thank you for the feedback.
The center of the breech block face is not flat. It is sunken down.Almost like someone machined a bevel,as its very even in shape. When I look inside the breech block it doesn't look pushed in. However its hard to make out small protrusions at the bottom of a dark tube!
On the primer flow,it looks like the primer is filling in the sunken part of the breech block face.AFAIK Fiocchi is a little hot,but the gun exhibits no excessive recoil.
I have all the dies and shells to reload 30 luger,but I have a bunch of Fiocchi ammo. I bought it ,when I thought production would be discontinued.
Hmmm.
Bob
Bob

02-23-2015, 11:04 AM	#4
saab-bob User Join Date: Jul 2009 Location: So Cal Posts: 459 Thanks: 774 Thanked 143 Times in 87 Posts	Gents. Thank you for the feedback. The center of the breech block face is not flat. It is sunken down.Almost like someone machined a bevel,as its very even in shape. When I look inside the breech block it doesn't look pushed in. However its hard to make out small protrusions at the bottom of a dark tube! On the primer flow,it looks like the primer is filling in the sunken part of the breech block face.AFAIK Fiocchi is a little hot,but the gun exhibits no excessive recoil. I have all the dies and shells to reload 30 luger,but I have a bunch of Fiocchi ammo. I bought it ,when I thought production would be discontinued. Hmmm. Bob Bob __________________ "I think,therefore I own guns"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode