New guy question on trigger pull

majbjd · 02-04-2013, 10:51 PM

Finally got a chance to pull the gun apart. The trigger bar engagement surface shows a mating surface about .060 deep and very slightly off square or worn toward the edge. The sear face shows the same depth of engagement. The face is square but there are two deep scratches running from the center to the edge. Could these be the cause of the light trigger?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-04-2013, 10:51 PM	#4
majbjd User Join Date: Jan 2013 Location: Abilene Texas Posts: 6 Thanks: 0 Thanked 1 Time in 1 Post	Finally got a chance to pull the gun apart. The trigger bar engagement surface shows a mating surface about .060 deep and very slightly off square or worn toward the edge. The sear face shows the same depth of engagement. The face is square but there are two deep scratches running from the center to the edge. Could these be the cause of the light trigger?