Barrel replacement illustrated

Blastattack · 08-12-2012, 08:15 PM

Thank you very much! I very much like your setup and plan on copying it. Currently I'm in the process of designing and drawing up the tooling i will need for this project. The wrench is almost fully designed now

Concerning the dimensions for your receiver block; did you reverse engineer them from your receiver(s) or did you take them from a blueprint, and shrink them a few thou?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-12-2012, 08:15 PM	#9
Blastattack User Join Date: Aug 2010 Location: Calgary AB Posts: 44 Thanks: 8 Thanked 8 Times in 8 Posts	Thank you very much! I very much like your setup and plan on copying it. Currently I'm in the process of designing and drawing up the tooling i will need for this project. The wrench is almost fully designed now Concerning the dimensions for your receiver block; did you reverse engineer them from your receiver(s) or did you take them from a blueprint, and shrink them a few thou?