Rebuilt artillery luger

mrerick · 04-26-2012, 08:26 PM

Marshall, there was considerable hand fitting done when Lugers were manufactured.

Switching out a breech block (toggle assembly) could end up changing headspace as well as the sear fit. If done by a competent Luger gunsmith, it would be fine...

Fine tune sites have a small screw that is turned by a very small spanner. Both the front and rear sights can come that way.

There would not be a rear site on the rear toggle of an Artillery...

Marc

04-26-2012, 08:26 PM	#7
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,920 Thanks: 1,377 Thanked 3,135 Times in 1,518 Posts	Marshall, there was considerable hand fitting done when Lugers were manufactured. Switching out a breech block (toggle assembly) could end up changing headspace as well as the sear fit. If done by a competent Luger gunsmith, it would be fine... Fine tune sites have a small screw that is turned by a very small spanner. Both the front and rear sights can come that way. There would not be a rear site on the rear toggle of an Artillery... Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode