Help needed from our Engineers.... <IMG SRC="/luger/graphics/indifferent.gif" BORDER=0 ALT=":|">

G.T. · 02-08-2001, 03:08 PM

I need to find an outfit that can perform the type of swaging and/or forming that is done on the feed end of the fxo type of magazine, feed lips, follower stops, etc. If anyone knows a provider of this type of forming (On thinwalled shapes other then round tube!) I would greatly appreciate a contact with them!.......Thanks, till...later...G.T.

Marvin · 02-08-2001, 04:00 PM

G.T.

See the attached link for a website to steel extrusions. This may of some help to you. The extrusion and lip forming dies are going to be very expensive to manufacture and you would be looking at a large quantity to justify the set-up costs. Good Luck and let me know if I can help you, but this week I am very busy working late every night.

Marvin

Steel Extrusions

02-08-2001, 03:08 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,523 Thanks: 1,321 Thanked 3,707 Times in 1,012 Posts	Help needed from our Engineers.... I need to find an outfit that can perform the type of swaging and/or forming that is done on the feed end of the fxo type of magazine, feed lips, follower stops, etc. If anyone knows a provider of this type of forming (On thinwalled shapes other then round tube!) I would greatly appreciate a contact with them!.......Thanks, till...later...G.T.

02-08-2001, 04:00 PM	#2
Marvin User Join Date: Jun 2002 Location: Upstate S.C. Posts: 1,132 Thanks: 0 Thanked 0 Times in 0 Posts	Re: Help needed from our Engineers.... G.T. See the attached link for a website to steel extrusions. This may of some help to you. The extrusion and lip forming dies are going to be very expensive to manufacture and you would be looking at a large quantity to justify the set-up costs. Good Luck and let me know if I can help you, but this week I am very busy working late every night. Marvin Steel Extrusions