Question, cleaning rod

schwob · 05-05-2002, 09:12 PM

Can anyone tell me, was there a special cleaning rod made for the Carbine Luger longer barrel?

Johnny Peppers · 05-05-2002, 09:44 PM

Yes. The ones that I have seen have been the commercial model with the oiler on one end.

schwob · 05-05-2002, 10:28 PM

John, would you know what the length of this rod would be?

Johnny Peppers · 05-05-2002, 11:21 PM

I sure don't know the exact length, but they would have been slightly longer than the 300mm barrel of the carbine.

Ron Wood · 05-05-2002, 11:30 PM

About 415mm including the short steel shank the brass rod screws into (i.e. as measured from the bottom of the oiler cylinder).

05-06-2002, 10:05 AM

For those not wanting to spend over a $100 for a luger carbine cleaning rod, I ran into a good deal years ago on some really nice repro wood handled Mauser Carbine rods, which will also work work in the luger, with 18 & 1/4" rod (including 2&1/4" jag) that can be removed and replaced by brush or cloth. I'm asking $35 each or 4 for $100 plus S&H. Tom

05-05-2002, 09:12 PM	#1
schwob RIP Join Date: Jun 2002 Location: Coast of Maine Posts: 273 Thanks: 0 Thanked 0 Times in 0 Posts	Question, cleaning rod Can anyone tell me, was there a special cleaning rod made for the Carbine Luger longer barrel?

05-05-2002, 09:44 PM	#2
Johnny Peppers User Join Date: Jun 2002 Location: Calion, Arkansas Posts: 1,042 Thanks: 0 Thanked 1 Time in 1 Post	Re: Question, cleaning rod Yes. The ones that I have seen have been the commercial model with the oiler on one end.

05-05-2002, 10:28 PM	#3
schwob RIP Join Date: Jun 2002 Location: Coast of Maine Posts: 273 Thanks: 0 Thanked 0 Times in 0 Posts	Re: Question, cleaning rod, length John, would you know what the length of this rod would be?

05-05-2002, 11:21 PM	#4
Johnny Peppers User Join Date: Jun 2002 Location: Calion, Arkansas Posts: 1,042 Thanks: 0 Thanked 1 Time in 1 Post	Re: Question, cleaning rod, length I sure don't know the exact length, but they would have been slightly longer than the 300mm barrel of the carbine.

05-05-2002, 11:30 PM	#5
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,022 Thanks: 1,090 Thanked 5,178 Times in 1,703 Posts	Re: Question, cleaning rod, length About 415mm including the short steel shank the brass rod screws into (i.e. as measured from the bottom of the oiler cylinder).

05-06-2002, 10:05 AM	#6
Tom Heller Guest Posts: n/a	Re: Carbine cleaning rods For those not wanting to spend over a $100 for a luger carbine cleaning rod, I ran into a good deal years ago on some really nice repro wood handled Mauser Carbine rods, which will also work work in the luger, with 18 & 1/4" rod (including 2&1/4" jag) that can be removed and replaced by brush or cloth. I'm asking $35 each or 4 for $100 plus S&H. Tom