luger presentation stand

Robb · 05-26-2013, 10:16 PM

I made a stand for a Luger I purchased off this forum for my son. I'm kind of proud of the stand and was wondering if anyone here could post the pics? I could forward them to someone if you were willing to post them.

Edward Tinker · 05-26-2013, 11:29 PM

Robb, there are 2 ways to post pictures on the forum.

1. Album, it will resize for you

2. You post direct here, it will resize to a certain degree

Robb · 05-27-2013, 12:45 AM

Thanks, I just had to play to figure it out.
The mag is just a piece of oak, I cut a notch in it for the mag catch and it actually works, the mag snaps into the gun when it's in place. I had a little plaque made telling the guns b-day and where made. Anyway, I thought it turned out well. It was my first experience using a router and it shows, but it's not bad.

Ron Wood · 05-27-2013, 12:48 AM

It did turn out well...nice job.

Edward Tinker · 05-27-2013, 01:00 AM

well done, looks great!

Zorba · 05-27-2013, 03:50 AM

Beautiful job! Be proud - you earned it!

05-26-2013, 11:29 PM	#2
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,974 Thanks: 2,072 Thanked 4,609 Times in 2,123 Posts	Robb, there are 2 ways to post pictures on the forum. 1. Album, it will resize for you 2. You post direct here, it will resize to a certain degree __________________ Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV

05-27-2013, 12:48 AM	#4
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,051 Thanks: 1,120 Thanked 5,287 Times in 1,728 Posts	It did turn out well...nice job. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-27-2013, 12:45 AM	#3
Robb User Join Date: May 2012 Posts: 19 Thanks: 0 Thanked 4 Times in 2 Posts	Thanks, I just had to play to figure it out. The mag is just a piece of oak, I cut a notch in it for the mag catch and it actually works, the mag snaps into the gun when it's in place. I had a little plaque made telling the guns b-day and where made. Anyway, I thought it turned out well. It was my first experience using a router and it shows, but it's not bad.

05-27-2013, 01:00 AM	#5
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,974 Thanks: 2,072 Thanked 4,609 Times in 2,123 Posts	well done, looks great!

05-27-2013, 03:50 AM	#6
Zorba User Join Date: Feb 2013 Location: Merritt Island, Fl Posts: 952 Thanks: 777 Thanked 528 Times in 290 Posts	Beautiful job! Be proud - you earned it!