Odd Ser #, "Diamonds", Rare?

john · 02-24-2002, 04:32 PM

Saw what I believe to be a .30 cal. commercial Luger yesterday that had an odd style of serial number proceeding and ending with stylized diamond symbols().

On the left front receiver, just below the C/N commercial proof was the serial # C11 6309 . The same ser # appeared on the back of the frame between the lanyard loop and the bottom of the rear toggle. Small parts appeared to be #'d in the commercial fashion. The front frame had the usual odd gothic lower case letter. As near as I could make out, this one was "i".

Does anyone know the significance of the diamond symbols before and after the serial #'s?

Thanks

Dok · 02-24-2002, 05:14 PM

I don't understand what the C11 is preceding the serial number? Lugers never had a letter preceding the serial number that I know of, and 116309 is too high a number even for a commercial Luger. Maybe one of the experts could enlighten me.

Dok

Orv Reichert · 02-24-2002, 08:55 PM

You are talking about a pistol that had the numbers removed at some time.

Later, the police got involved and the gun went to the California state agency [Sacramento] which numbered it with the next number and the CII.

They probably tried to 'raise' the original numbers..not always possible! could not return an gun without a number ..... so..........

I think the Agency is CALIF INVESTIGATION AND IDENTIFICATION or something similar?

If you need, I can get you the correct agency name and address?

Orv Reichert

Dok · 02-24-2002, 10:53 PM

john · 02-25-2002, 03:04 AM

Orv,

All the #'s match. Why would some agency go to the trouble of stamping a new ser # on both the frame and the receiver and do so with the new Ser #'s last two digits matching the other #'d parts?

Orv Reichert · 02-25-2002, 04:35 AM

All I know is that the CII who does the forensic work for the State of Calif. use that CII prefix and a number with the before and after when they apply a number to a gun.[I used to work for a Police Dept in California]

Perhaps the numbers had all been altered..in that case,they would apply the CII number to each location. Naturally, they would not number a gun that had numbers unless they had been altered or obliterated.

I once owned a Mod HP that had been through that process. They renumbered the frame with that exact procedure/marks. We could read the original numbers through the blue on the two other locations [with the proper lighting]

Buxton comments on that procedure in California and other states in his P38 book.

Orv Reichert

02-25-2002, 02:06 PM

Hi Orv,

Sounds like you have the mystery solved.

Thanks,

JPD

02-24-2002, 04:32 PM	#1
john User Join Date: Jun 2002 Posts: 27 Thanks: 0 Thanked 0 Times in 0 Posts	Odd Ser #, "Diamonds", Rare? Saw what I believe to be a .30 cal. commercial Luger yesterday that had an odd style of serial number proceeding and ending with stylized diamond symbols(). On the left front receiver, just below the C/N commercial proof was the serial # C11 6309 . The same ser # appeared on the back of the frame between the lanyard loop and the bottom of the rear toggle. Small parts appeared to be #'d in the commercial fashion. The front frame had the usual odd gothic lower case letter. As near as I could make out, this one was "i". Does anyone know the significance of the diamond symbols before and after the serial #'s? Thanks

02-24-2002, 05:14 PM	#2
Dok RIP Join Date: Jun 2002 Location: Bermuda (Eat Your Heart Out) Posts: 1,626 Thanks: 0 Thanked 3 Times in 3 Posts	Re: Odd Ser #, "Diamonds", Rare? I don't understand what the C11 is preceding the serial number? Lugers never had a letter preceding the serial number that I know of, and 116309 is too high a number even for a commercial Luger. Maybe one of the experts could enlighten me. Dok

02-24-2002, 08:55 PM	#3
Orv Reichert RIP Join Date: Jun 2002 Location: SW Washington State Posts: 339 Thanks: 0 Thanked 0 Times in 0 Posts	Not Rare You are talking about a pistol that had the numbers removed at some time. Later, the police got involved and the gun went to the California state agency [Sacramento] which numbered it with the next number and the CII. They probably tried to 'raise' the original numbers..not always possible! could not return an gun without a number ..... so.......... I think the Agency is CALIF INVESTIGATION AND IDENTIFICATION or something similar? If you need, I can get you the correct agency name and address? Orv Reichert

02-24-2002, 10:53 PM	#4
Dok RIP Join Date: Jun 2002 Location: Bermuda (Eat Your Heart Out) Posts: 1,626 Thanks: 0 Thanked 3 Times in 3 Posts	Thanks Orv! (EOM)

02-25-2002, 03:04 AM	#5
john User Join Date: Jun 2002 Posts: 27 Thanks: 0 Thanked 0 Times in 0 Posts	Question Response Orv, All the #'s match. Why would some agency go to the trouble of stamping a new ser # on both the frame and the receiver and do so with the new Ser #'s last two digits matching the other #'d parts?

02-25-2002, 04:35 AM	#6
Orv Reichert RIP Join Date: Jun 2002 Location: SW Washington State Posts: 339 Thanks: 0 Thanked 0 Times in 0 Posts	response All I know is that the CII who does the forensic work for the State of Calif. use that CII prefix and a number with the before and after when they apply a number to a gun.[I used to work for a Police Dept in California] Perhaps the numbers had all been altered..in that case,they would apply the CII number to each location. Naturally, they would not number a gun that had numbers unless they had been altered or obliterated. I once owned a Mod HP that had been through that process. They renumbered the frame with that exact procedure/marks. We could read the original numbers through the blue on the two other locations [with the proper lighting] Buxton comments on that procedure in California and other states in his P38 book. Orv Reichert

02-25-2002, 02:06 PM	#7
John Drolet Guest Posts: n/a	Re: response Hi Orv, Sounds like you have the mystery solved. Thanks, JPD

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode