my profile |
register |
faq |
search upload photo | donate | calendar |
|
07-02-2010, 09:44 PM | #1 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
Looks like I found my first Luger
I started this thread about six hours ago. Finally finished it a little while ago and got a timeout message when I tried to post it. So I had to start over. Argh!
I have been learning a lot about these guns over the past few weeks and I decided a matching numbers gun was the right choice for me. I've been searching around and the rumours are true; there are more fakes out there than honest guns...and sellers. Sad but true. It only took me a few weeks to learn this and I'm guessing it could take years for me to fully understand what's real and what's not. So I checked out some dealers. One reputable dealer, although somewhat pricey, struck me as straightforward and represented their inventory honestly. One piece in particular interested me: A 1936 S/42 Matching number, except mag No holster or papers Three digit number (three???) on left side of receiver, underside of barrel and underside of frame 90% blue, 60% straw, with typical holster wear (which is far better than no wear) I'd love to show some photos of the acceptance stamps, which appear to be of the "63" variety, but it's hard to tell. In any case, they're holding this for me and my plan is to finish the deal next week!! Definitely more than I planned on spending but I rather an expensive success than a cheap mistake. I'm looking forward to photographing it and posting up the pics for your input. Jim |
07-02-2010, 09:57 PM | #2 |
Patron
LugerForum Patron Join Date: Mar 2009
Location: Colorado
Posts: 978
Thanks: 68
Thanked 127 Times in 108 Posts
|
The 1936 is a great place to start. A lot of folks considered them the best finished of the Mausers lugers. E/63s would be correct. Then the early, or mid test proof.
We eagerly await your pics! We love pics. congrats! FN Last edited by FNorm; 07-02-2010 at 09:58 PM. Reason: sp |
07-02-2010, 09:59 PM | #3 | |
User
Join Date: Aug 2009
Location: MD / Currently about 9000 klicks east of the Potomac
Posts: 497
Thanks: 100
Thanked 47 Times in 35 Posts
|
Quote:
__________________
Regards, Andy There's No Place Like Home (Wizard Of Oz) |
|
07-02-2010, 10:25 PM | #4 |
User
Join Date: Feb 2004
Location: Orygun
Posts: 4,243
Thanks: 118
Thanked 245 Times in 150 Posts
|
Fred's right. One of my first high end collectable Lugers was a 1936. I had a choice between a 1940 and the '36 in equal condition and same price. I took the '36 because of the beautiful blue and straw.
Welcome to the ward. Ron
__________________
I Still Need DWM side plate #49... if anyone runs across a nice one. What ~Rudyard Kipling~ said... |
07-03-2010, 06:44 AM | #5 |
Super Moderator
Eternal Lifer LugerForum Patron Join Date: Jun 2002
Location: North of Spokane, WA
Posts: 15,926
Thanks: 2,014
Thanked 4,523 Times in 2,089 Posts
|
If I know I am going to take a long time, I make my draft in my word processor (Word) and then copy and paste it into the reply area
ed
__________________
Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV |
07-03-2010, 06:01 PM | #6 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
Oh, and thanks go to Ed and a few others on here who I bugged several times.
|
07-06-2010, 11:13 PM | #7 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
Update (because I'm impatient): I pretty much have to finish the deal this week. It could be at least a few weeks before it's in my possession, though. I've been chasing around the State Trooper I need to meet up with in order to get my application for another pistol purchase permit processed here in NJ. It takes time.
In the meantime, finances took a bit of a turn for the worse and I'm a little hesitant, particularly because I know I'm really paying on the high side of retail for this gun. It isn't super nice, either; it just appears to be as described, which itself is important. My justification thus far has been that this gun, even though pricey at around $1500 (no holster or tool, non-matching mag), is a better deal than buying a $900 piece on gunbroker, only to find it to be a fake. On the other, other hand, there's a pretty big gun show local to me this weekend and I feel *more* confident as a shopper, since I'm been pouring over the forums, FAQs, etc. for the past week. It has been a blast. Your collective words of wisdom are very welcomed at this point. |
11-26-2010, 09:52 PM | #8 | |
User
Join Date: Sep 2010
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
|
Quote:
|
|
11-26-2010, 11:58 PM | #9 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
Thanks for the offer! It looks like I'm a few counties away, though. I belong to a local range and really want to frequent it with my other gun, but it's been months.
|
07-07-2010, 09:39 AM | #10 |
Patron
LugerForum Patron Join Date: Mar 2009
Location: Colorado
Posts: 978
Thanks: 68
Thanked 127 Times in 108 Posts
|
Shows are good even if you don't buy anything. Get the close up, hands on time. Ask questions.
But be prepared. As in bring cash. Almost always I find something I want to bring home. Little treasures.... Go with a good flashlight, I like the Surefire type, and a good magnifying glass. FN |
07-07-2010, 09:51 AM | #11 |
User
Join Date: Jun 2010
Location: Northern Kentucky
Posts: 62
Thanks: 1
Thanked 5 Times in 2 Posts
|
Jimmy, I see we're both new Luger owners I have a new to me 1915, my second choice was a 1936. I'm going to post pictures maybe this evening. I read in you post "I've been chasing around the State Trooper I need to meet up with in order to get my application for another pistol purchase permit processed here in NJ. It takes time."? Strange I did read that requirement in the 2nd Amendment. Perhaps last weeks court ruling will stop some of this abuse for law bidding citizens. I look forward to seeing your 36.
Regards; Bill |
07-07-2010, 10:02 AM | #12 |
Super Moderator - Patron
LugerForum Life Patron Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,907
Thanks: 1,374
Thanked 3,108 Times in 1,509 Posts
|
There are collectors in my area that bring Lugers to gun shows to display. They are not for sale.
Discussions with them, and close inspection of actual collectible Lugers - priceless! I did buy my first Luger (1 1923 Alphabet commercial DWM) at a show. It turned out that my offered price was right in line with it's value. I didn't have a fraction of the knowledge needed to make an informed decision at that point. I was just lucky. 75 percent of the Lugers I've seen at shows after that have had some defect that would turn off a collector. Parts swaps; refinished; pitting problems etc... Yet each one was priced as if it was collectible. I actually had one seller tell me that an all matching Mauser Luger (except for the trigger plate which had a "42" serial number on it) was all matching because "42" was the Mauser code number. If armory replacement parts like the trigger plate were marked "42" by Mauser, it's the first I've heard of it! If this is actually true, I'd love to verify that here. The last show had a seller that wouldn't give me any contact information, but told me he was visiting from California - across the US from us here in Raleigh. He had three Lugers that were "Perfect condition". An American Eagle priced in the $5,000 range. Two Mausers - they were only $3,500 each. I looked closely at them and found that both Mausers had been re-crowned to a flat - square crown. In the white because they had been refinished and messed with in other ways. It almost seems that "boosting" that value of a Luger has become a way of life at gun shows. Marc |
07-07-2010, 10:38 AM | #13 |
User
Join Date: Aug 2002
Location: Ohio
Posts: 106
Thanks: 0
Thanked 11 Times in 7 Posts
|
Mrerick...... In fact replacement parts were stamped "42" and "S/42" by Mauser. It was their code at different times during production. It was their acceptance stamp of the various replacement parts.
__________________
dave |
The following member says Thank You to tau-delt for your post: |
07-07-2010, 06:33 PM | #14 |
Super Moderator - Patron
LugerForum Life Patron Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,907
Thanks: 1,374
Thanked 3,108 Times in 1,509 Posts
|
Tau-delt,
Thanks for this background information! I do understand the use of S/42 and 42 on the forward toggle. Didn't know they used it on other parts... On a trigger side plate, would Mauser have stamped the "42" in the same location that they normally stamped the last two digits of a serial number? Marc |
07-08-2010, 11:37 AM | #15 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
This is the gun:
http://www.simpsonltd.com/product_in...5462fadfa1cefb From what I've been able to determine, it has been in their inventory for a long time. Feel free to browse the photos and let me know what you think. |
07-08-2010, 12:18 PM | #16 |
Patron
LugerForum Patron Join Date: Jun 2002
Location: POB 398 St.Charles,MO. 63302
Posts: 5,089
Thanks: 6
Thanked 736 Times in 483 Posts
|
Marc, A smaller die set 42 or S/42 armour's spare parts code will NOT be stamped in the same location as a serial number. It will usually be stamped inside or in a locaton that is covered when installed. Tom
Last edited by Lugerdoc; 07-08-2010 at 12:20 PM. Reason: typing error |
07-29-2010, 02:50 PM | #17 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
UPDATE:
Not much, but I felt like posting....I've just sent in the balance of the payment. I'm three weeks into waiting for my purchase permit to come through, which could take 2-3 more months or longer. I'm hoping for less. I can't wait! I just read a short but enjoyable book by Donn Pearce, entitled "Nobody Comes Back." It's a fictional account of sixteen year old infantryman who served in Belgium near the end of WWII. He was captured twice by the Germans and managed to escape. No mention of Lugers anywhere but I really enjoyed it, nonetheless. Any other suggestions for some reading? Maybe a good idea for a thread, if one hasn't already been created. |
10-17-2010, 09:56 PM | #18 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
Argh... three and a half months and still no permit from NJ. There are lawyers now that specialize in pressing the state for an answer, as the NJ constitution states that a decision must be rendered within 30 days, if I recall correctly.
On the other hand, this gun does qualify for a C&R purchase but I don't know to much about it and figure it wouldn't help me get the gun any faster; I think the dealer requirements are the only difference. Can someone clarify? |
11-25-2010, 10:57 AM | #19 |
User
Join Date: Aug 2009
Posts: 36
Thanks: 1
Thanked 0 Times in 0 Posts
|
I finally received my purchase permit from NJ (four and a half months!) and picked up the gun yesterday. Pics will be posted in a new thread when I get a chance for a photo shoot. Happy Thanksgiving, everyone!
|
11-26-2010, 07:23 AM | #20 |
User
Join Date: Oct 2010
Posts: 24
Thanks: 5
Thanked 3 Times in 1 Post
|
Just read through the postings and glad to hear you've now got your Luger.
You asked for a book recommendation. Look on Amazon for "Assault from within" written by George Von Konrat. Its based on a true story - I know someone who was in this type of unit. Here's the write-up from Amazon: The book tells the tale of an elite unit of very young German soldiers, trained from teenage years, to pass as Russians. When the invasion of the Soviet Union is launched, these soldiers are infiltrated as "5th columnists" to create chaos and sabotage, in the Russian lines, as the German army launches their offensive. One of the best war stories that I have read, this is said to be based on fact. The story is told from the German viewpoint, so Russian readers would probably not enjoy this book. All in all, a good read that stands the test of time. |
|
|