my profile |
register |
faq |
search upload photo | donate | calendar |
07-26-2005, 10:56 PM | #1 |
User
Join Date: Aug 2004
Posts: 88
Thanks: 16
Thanked 8 Times in 5 Posts
|
Sear spring replacement
I am replacing the sear spring on a mauser luger. The new replacement spring seems to long. Are these constructed overly long and made to be shortened? Thanks. Jim
|
07-27-2005, 09:35 AM | #2 |
Patron
LugerForum Patron Join Date: Jun 2002
Location: POB 398 St.Charles,MO. 63302
Posts: 5,089
Thanks: 6
Thanked 736 Times in 483 Posts
|
I too have found quite a variance in length of these. I believe that they were originally hand fitted to sears of various lengths. TH
|
07-27-2005, 10:09 AM | #3 |
User
Join Date: Jun 2002
Location: NC - USA
Posts: 1,239
Thanks: 0
Thanked 18 Times in 6 Posts
|
Tom,
I have noticed the same thing with this spring. Is it safe to grind a little off the rear end, or is there a danger that the heat from grinding might affect the spring characteristics? Luke
__________________
"Peace, if possible; truth, at any cost." . . . Martin Luther |
07-27-2005, 10:48 AM | #4 |
Lifer
Lifetime Forum Patron Join Date: Jun 2002
Location: The Capital of the Free World
Posts: 10,150
Thanks: 3,003
Thanked 2,304 Times in 1,096 Posts
|
Luke, Just take very small 'bites" with the grinder and dip the item in cold water between engagements with the grindstone.... you should have no problems... use cold blue for touchup of the bare surfaces.
BTW Luke, my Kreighoff Parabellum book just arrived yesterday from Simpson's LTD... I have already devoured it cover to cover! What a great book. I had never owned this one before...
__________________
regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL and are endowed by their Creator with certain UNALIENABLE rights, and among these are life, LIBERTY, and the pursuit of happiness..." |
07-27-2005, 01:35 PM | #5 |
User
Join Date: Aug 2004
Posts: 88
Thanks: 16
Thanked 8 Times in 5 Posts
|
Thanks to all for the info. I was worried I might ruin the spring by grinding on it. Jim
|
07-27-2005, 01:50 PM | #6 |
Lifer
Lifetime Forum Patron Join Date: Jun 2002
Location: The Capital of the Free World
Posts: 10,150
Thanks: 3,003
Thanked 2,304 Times in 1,096 Posts
|
JimmieJ Just be careful not to disturb the width of the spring. That dimension is very carefully sized to fit the recess in the frame... Length is not that critical, as long as the final length completely fills the notch in the sear when installed.
__________________
regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL and are endowed by their Creator with certain UNALIENABLE rights, and among these are life, LIBERTY, and the pursuit of happiness..." |
07-27-2005, 08:38 PM | #7 |
User
Join Date: Aug 2004
Posts: 88
Thanks: 16
Thanked 8 Times in 5 Posts
|
Thanks John.
I was more worried about ruining the spring by heating it with a grindstone. Your previous post was what I needed to know. Jim |
|
|