Toggle Axle Retaining Pin

ma deuce · 06-26-2011, 06:05 PM

The little pin on top of the left knob of the toggle. Mine works out as I shoot, and I have to tap it back in. What's the best way of preventing this? Will Loctite work?

lugerholsterrepair · 06-26-2011, 06:50 PM

Paul, They make a red Locktite I think that locks pretty good. If it works out that easily I would take a closer look at replacing it. It might be a bad replacement as it is.

ma deuce · 06-26-2011, 10:58 PM

Thank, Jerry. If the Loctite route doesn't do it, I guess that's what I'll have to do. Other than the one pin, the gun's pretty tight.

Paul

ma deuce · 06-28-2011, 10:00 PM

Thanks for the advice. If I go looking for a replacement pin, what's the correct terminology for the part? I'll check Numrich - any other suggestions?

Paul

alanint · 06-28-2011, 10:15 PM

Contact Tom Heller, (Luger Doc) here on the site. Tom should have this pin for you.

06-26-2011, 06:05 PM	#1
ma deuce User Join Date: Jul 2010 Location: People's Republic of Maryland Posts: 14 Thanks: 0 Thanked 0 Times in 0 Posts	Toggle Axle Retaining Pin The little pin on top of the left knob of the toggle. Mine works out as I shoot, and I have to tap it back in. What's the best way of preventing this? Will Loctite work?

06-26-2011, 06:50 PM	#2
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Paul, They make a red Locktite I think that locks pretty good. If it works out that easily I would take a closer look at replacing it. It might be a bad replacement as it is. __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-26-2011, 10:58 PM	#3
ma deuce User Join Date: Jul 2010 Location: People's Republic of Maryland Posts: 14 Thanks: 0 Thanked 0 Times in 0 Posts	Thank, Jerry. If the Loctite route doesn't do it, I guess that's what I'll have to do. Other than the one pin, the gun's pretty tight. Paul

06-28-2011, 10:00 PM	#4
ma deuce User Join Date: Jul 2010 Location: People's Republic of Maryland Posts: 14 Thanks: 0 Thanked 0 Times in 0 Posts	Thanks for the advice. If I go looking for a replacement pin, what's the correct terminology for the part? I'll check Numrich - any other suggestions? Paul

06-28-2011, 10:15 PM	#5
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	Contact Tom Heller, (Luger Doc) here on the site. Tom should have this pin for you.