655 Tool opinions?

bobcam1 · 03-27-2009, 05:08 PM

Hello, all.....
This tool is part of a holster/tool deal that I'm about to pull the trigger on, and I'd appreciate some opinions on it.
These are the only photos that I have, and I hope they're sufficient.

Thank you,
Bob.

bobcam1 · 03-27-2009, 05:10 PM

oops....found one more....

G.T. · 03-27-2009, 10:48 PM

Hi Bob, looks real to me.... although the condition makes it marginaly collectable... If priced right, I'd go for it!! Best to you, til...lat'r...GT

lugerholsterrepair · 03-27-2009, 11:41 PM

Bob, Like GT..it looks good so far..I would take off the finish, oil or shellack or whatever is on it. Then you can get a good look at it. i suppose you have measured it for thickness?

You need to see the strike a lot better.

Jerry Burney

alamar · 03-28-2009, 01:05 AM

Is there by chance a guide/faq that would tell someone what to look for? I have a few tools that have come with various rigs. based on how/who i acquired these Lugers from, i have no real doubts about the authenticity of my tools but would like to check.

Thanks in adavance.

03-27-2009, 10:48 PM	#3
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,742 Times in 1,020 Posts	655 tool Hi Bob, looks real to me.... although the condition makes it marginaly collectable... If priced right, I'd go for it!! Best to you, til...lat'r...GT

03-27-2009, 11:41 PM	#4
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Bob, Like GT..it looks good so far..I would take off the finish, oil or shellack or whatever is on it. Then you can get a good look at it. i suppose you have measured it for thickness? You need to see the strike a lot better. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-28-2009, 01:05 AM	#5
alamar User Join Date: Jul 2005 Posts: 79 Thanks: 7 Thanked 11 Times in 6 Posts	Is there by chance a guide/faq that would tell someone what to look for? I have a few tools that have come with various rigs. based on how/who i acquired these Lugers from, i have no real doubts about the authenticity of my tools but would like to check. Thanks in adavance.