is this correct

bergwerk · 05-17-2009, 04:40 AM

hi all yesterday i had a very proud day , my 41 byf roared back into life , so good to see a living part of history in action and the report leaves you in no doubt to its function . anyhow after firing one round the centre toggle link remained slightly proud [about 5-10mm] and looked as though it would need to be pushed flush to fire another one [ based purely on watching videos of the luger firing . didnt want to break my treasured p08 , but on removal of the magazine and checking the chamber was clear , i found another round was chambered so am i panicking over nothing - if not what do you guys think could be up . thanks

John Sabato · 05-18-2009, 09:34 AM

Dirty chamber? or dirty ammunition didn't allow for a full chambering of the round. Clean it, make sure everything moves smoothely and try it again.

jonnyc · 05-18-2009, 03:32 PM

Also ensure that all your moving parts are properly lubed. I have received completely dry pistols in the past. Every "new" gun should be stripped, cleaned, and lubed before first firing.

05-17-2009, 04:40 AM	#1
bergwerk User Join Date: Nov 2008 Location: north Posts: 59 Thanks: 16 Thanked 0 Times in 0 Posts	is this correct hi all yesterday i had a very proud day , my 41 byf roared back into life , so good to see a living part of history in action and the report leaves you in no doubt to its function . anyhow after firing one round the centre toggle link remained slightly proud [about 5-10mm] and looked as though it would need to be pushed flush to fire another one [ based purely on watching videos of the luger firing . didnt want to break my treasured p08 , but on removal of the magazine and checking the chamber was clear , i found another round was chambered so am i panicking over nothing - if not what do you guys think could be up . thanks

05-18-2009, 09:34 AM	#2
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	Dirty chamber? or dirty ammunition didn't allow for a full chambering of the round. Clean it, make sure everything moves smoothely and try it again. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-18-2009, 03:32 PM	#3
jonnyc User Join Date: Dec 2008 Posts: 425 Thanks: 2 Thanked 46 Times in 34 Posts	Also ensure that all your moving parts are properly lubed. I have received completely dry pistols in the past. Every "new" gun should be stripped, cleaned, and lubed before first firing.