Brass drift punch?

Ray K · 01-25-2008, 11:52 PM

What's the diameter of the brass drift punch required to remove the extractor in a P08? And, where are they available if I decide not to make one myself? Thanks. I've seen some advertised for $30+ but would rather just buy a cheap one that does the job.

j.rom · 01-26-2008, 03:59 AM

I am using a wooden toothpick for this job. Put your thumb on top of the breach block, push extractor a little bit down and then push the pin with a toothpick. It always works for me. Be careful not to loose the small spring under the extractor.

Regards,
Jan.

01-25-2008, 11:52 PM	#1
Ray K User Join Date: Nov 2007 Posts: 23 Thanks: 0 Thanked 0 Times in 0 Posts	Brass drift punch? What's the diameter of the brass drift punch required to remove the extractor in a P08? And, where are they available if I decide not to make one myself? Thanks. I've seen some advertised for $30+ but would rather just buy a cheap one that does the job. __________________ Ray Kammer Orlando, Florida

01-26-2008, 03:59 AM	#2
j.rom New User Join Date: Dec 2005 Location: Atlanta, GA Posts: 4 Thanks: 0 Thanked 0 Times in 0 Posts	Brass drift punch? I am using a wooden toothpick for this job. Put your thumb on top of the breach block, push extractor a little bit down and then push the pin with a toothpick. It always works for me. Be careful not to loose the small spring under the extractor. Regards, Jan.