, Collector Forums" /> Lugerforum Archive" />
my profile |
register |
faq |
search upload photo | donate | calendar |
02-08-2001, 03:08 PM | #1 |
Lifer
Lifetime Forum Patron Join Date: Jun 2002
Location: Chandler Arizona
Posts: 3,503
Thanks: 1,318
Thanked 3,641 Times in 1,002 Posts
|
Help needed from our Engineers....
I need to find an outfit that can perform the type of swaging and/or forming that is done on the feed end of the fxo type of magazine, feed lips, follower stops, etc. If anyone knows a provider of this type of forming (On thinwalled shapes other then round tube!) I would greatly appreciate a contact with them!.......Thanks, till...later...G.T.
|
02-08-2001, 04:00 PM | #2 |
User
Join Date: Jun 2002
Location: Upstate S.C.
Posts: 1,132
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Help needed from our Engineers....
G.T.
See the attached link for a website to steel extrusions. This may of some help to you. The extrusion and lip forming dies are going to be very expensive to manufacture and you would be looking at a large quantity to justify the set-up costs. Good Luck and let me know if I can help you, but this week I am very busy working late every night. Marvin Steel Extrusions |
|
|