Re: Luger ammo
Gruss Gott all!
I've been reading through the info.
presented here and I have a couple of
questions I'd like to toss in if that's
alright.I've read that one of the problems with the Luger is that it takes a "hot" rd. to cycle the action and that alot of the modern ammo doesn't produce sufficient
pressure to do the job.Is this purely a
case of misinformation by the authors or
do acceptable "standard pressure" loads
(as opposed to +P and +P+) vary to such
a degree in a general sense that one can't
rely at all on the designation that ammo
is "standard" pressure?
My stainless pistols seem to like 115gr
PMP ( South African ).Does anyone have
the data on where this ammo fits into the
grand scheme of things in this regard?
Kryrie,you mentioned part of the problem I'm seeing with one of these guns might be at least partially due to the load.Are
you familiar with this particular cartridge and its performance?Could this be a contributing factor to the errosion
on the frame that I've seen?
Sorry for running on,but I "needs to know" more than I do at this point about
almost everything!Thanks!
Tschuss! Mark
|