LugerForum Discussion Forums - View Single Post

milesc2 · 10-11-2017, 10:12 AM

Wanted to show the progress I have made refreshing my mixed numbers 1916 DWM shooter.

It was completely dip blued at one point. I have stripped most of the parts that should be in the white with the exception of the S-link and toggle pin. (I tried the drill press method but still can't get the pins out)

I am considering sending it to Ted to have it refinished but I am not sure if the buffing damage is reparable for a reasonable cost.

Can someone explain how the trigger springs are re fire blued on restored guns? I have no problems with the screws but I am afraid if I try to heat the spring it will destroy the temper.

If a new spring must be purchased does anyone know where I could locate a correct fire blued one?

Thanks,
-Miles

10-11-2017, 10:12 AM	#1
milesc2 User Join Date: Dec 2016 Location: Kansas City Posts: 214 Thanks: 324 Thanked 249 Times in 66 Posts	DWM Shooter Refresh Wanted to show the progress I have made refreshing my mixed numbers 1916 DWM shooter. It was completely dip blued at one point. I have stripped most of the parts that should be in the white with the exception of the S-link and toggle pin. (I tried the drill press method but still can't get the pins out) I am considering sending it to Ted to have it refinished but I am not sure if the buffing damage is reparable for a reasonable cost. Can someone explain how the trigger springs are re fire blued on restored guns? I have no problems with the screws but I am afraid if I try to heat the spring it will destroy the temper. If a new spring must be purchased does anyone know where I could locate a correct fire blued one? Thanks, -Miles Attached Thumbnails