LugerForum Discussion Forums - View Single Post

mrerick · 12-11-2018, 09:37 AM

You'll find our forum's FAQ PDF document by following the "FAQ" link at the top of every page. It's got quite a bit of detailed information about Lugers, markings, variations and other history. It's the accumulated knowledge of the forum gathered over many years.

You should check the side plate to verify it's matching. The exterior number will be the last digits of the serial number. Inside the plate, toward the bottom where the trigger bar hinge is located, you'll find numbers that should correspond to the first digits of the serial number.

It's got a fair amount of finish wear. Normally the trigger, receiver locking bar, safety and extractor are a golden color "strawed" finish, accomplished through heating and quenching the parts. Over time this straw can fade to more black in color, and that may have happened with your Luger.

I see your listings to buy a magazine and loading tool. My recommendation is to take some time, enjoy the Luger you have bought and spend the money on some of the reference books. The best available today is the Sturgess book published by Bob Simpson at Simpsonltd.com. It seems expensive, but is worth every penny.

Welcome to the forum,

Marc

12-11-2018, 09:37 AM	#13
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,900 Thanks: 1,372 Thanked 3,094 Times in 1,503 Posts	You'll find our forum's FAQ PDF document by following the "FAQ" link at the top of every page. It's got quite a bit of detailed information about Lugers, markings, variations and other history. It's the accumulated knowledge of the forum gathered over many years. You should check the side plate to verify it's matching. The exterior number will be the last digits of the serial number. Inside the plate, toward the bottom where the trigger bar hinge is located, you'll find numbers that should correspond to the first digits of the serial number. It's got a fair amount of finish wear. Normally the trigger, receiver locking bar, safety and extractor are a golden color "strawed" finish, accomplished through heating and quenching the parts. Over time this straw can fade to more black in color, and that may have happened with your Luger. I see your listings to buy a magazine and loading tool. My recommendation is to take some time, enjoy the Luger you have bought and spend the money on some of the reference books. The best available today is the Sturgess book published by Bob Simpson at Simpsonltd.com. It seems expensive, but is worth every penny. Welcome to the forum, Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.