View Single Post
Unread 11-05-2020, 12:25 PM   #12
G.T.
Lifer
Lifetime Forum
Patron
 
Join Date: Jun 2002
Location: Chandler Arizona
Posts: 3,483
Thanks: 1,282
Thanked 3,579 Times in 988 Posts
Default if that's so, then this must be so!

Hi to all, in reading Rons and Dons posts it would seem that a spring with equal thickness thin (.75 to .85) leafs, (measured at the same spot every time) would be for the 1900 .30 as well as the 02 .30 carbines with the forearm assist spring?
Then it gets kind a blurry as to application?........ I would think any additional thickness would be for another application, 9mm and such, and at that time probably far less common. As Don suggests, they could have increased the leaf thickness on both leaves a little and made a "catch all" spring that crossed over both ways?... any more thoughts and real time measurements as to application? .... best, til....lat'r.....GT
G.T. is offline   Reply With Quote
The following 2 members says Thank You to G.T. for your post: