Quote:
Originally Posted by Doubs
Put a piece of masking tape on the top of the lower L-arm where it slips under the trigger. That will increase the thickness of the L-arm and the upper L-arm will be pushed in farther at the top. It may require two thicknesses of masking tape but it should release the firing pin sooner as the trigger is depressed. If that improves your trigger pull then add a little JB Weld to the lower L-arm and file it down until the trigger pull is as you want it.
|
I can try the masking tap trick. As for JB weld, I think I would buy another of the 'L' pieces and try it with the 'new' one that way I could always swap the original back if I ever decide to sell it, though I tend not to do that.
Thank you!