LugerForum Discussion Forums - View Single Post

Ron Wood · 09-22-2014, 03:38 PM

The 1900 extractor is really just a spring. The rear of the extractor is a pin that fits into the breech block and is held in place by the spring tension on a lug on the lower side of the extractor. To remove the extractor, you have to use a tool, preferably something non-marring like a wood dowel shaped like a screwdriver on the end, and lift up on the forward end of the extractor (the part that grasps the cartridge) until the lug is free and you can slide the extractor forward to remove it. A risky process on an old and/or brittle extractor, but that is the way you do it.

09-22-2014, 03:38 PM	#2
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 6,986 Thanks: 1,065 Thanked 5,088 Times in 1,674 Posts	The 1900 extractor is really just a spring. The rear of the extractor is a pin that fits into the breech block and is held in place by the spring tension on a lug on the lower side of the extractor. To remove the extractor, you have to use a tool, preferably something non-marring like a wood dowel shaped like a screwdriver on the end, and lift up on the forward end of the extractor (the part that grasps the cartridge) until the lug is free and you can slide the extractor forward to remove it. A risky process on an old and/or brittle extractor, but that is the way you do it. Attached Images __________________ If it's made after 1918...it's a reproduction Last edited by Ron Wood; 09-22-2014 at 04:24 PM.