LugerForum Discussion Forums - View Single Post - Luger will not fire until the trigger is pulled twice.

mrerick · 08-05-2012, 01:27 AM

Sounds like the disconnector ( the little plunger at the front of the sear bar) may not be resetting properly until bumped by the trigger bar. Check it to make sure it's clean and lubricated.

Also look at the small axle pin (the fulcrum) that the sear bar rotates around. Make sure it's clean and in position.

Marc

08-05-2012, 01:27 AM	#3
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,900 Thanks: 1,372 Thanked 3,094 Times in 1,503 Posts	Sounds like the disconnector ( the little plunger at the front of the sear bar) may not be resetting properly until bumped by the trigger bar. Check it to make sure it's clean and lubricated. Also look at the small axle pin (the fulcrum) that the sear bar rotates around. Make sure it's clean and in position. Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.