LugerForum Discussion Forums - View Single Post - Killing mold on holsters and preservation

Mrgunguy · 04-27-2020, 02:59 PM

In the past I’ve cleaned off the particulate matter with warm water and then left the holster out in the direct sunlight for as long as I could. I then wipe it down with acetone and treat it with the old Connolly’s. It seems to work pretty good. Only once have I had to do it again because of a little bit coming back.

Good luck! Mold is a bear to get rid of.

04-27-2020, 02:59 PM	#4
Mrgunguy Patron LugerForum Patron Join Date: Apr 2020 Posts: 29 Thanks: 12 Thanked 49 Times in 9 Posts	In the past I’ve cleaned off the particulate matter with warm water and then left the holster out in the direct sunlight for as long as I could. I then wipe it down with acetone and treat it with the old Connolly’s. It seems to work pretty good. Only once have I had to do it again because of a little bit coming back. Good luck! Mold is a bear to get rid of. Last edited by lugerholsterrepair; 04-27-2020 at 04:54 PM.