ATF regulations have changed at least 3 times since 1968 as to placement , size , + content - - like the one shown in picture does not have country of origin which is now a current requirement -
i believe this to be the most current
- Title 27 CFR Part 478.92 requires that within 15 days after release from Customs custody, each firearm imported shall be identified by engraving or casting the serial number on the frame or receiver; in addition, the following (1) model, (2) caliber or gauge, (3) name of manufacturer an country where manufactured and (4) the name, city and State of the importer shall be engraved, cast or stamped on the frame, receiver or barrel. must be to a minimum depth of.003 inch and in a print size no smaller than 1/16 inch Name of Manufacturer Must be conspicuously engraved, cast or stamped (impressed) on the firearm frame, receiver, barrel or slide - ]
|