LugerForum Discussion Forums - View Single Post

Major Tom · 12-10-2019, 03:43 AM

With help from a member here, I got this pistol assembled. The original problem was that a round would not chamber because the breach block did not go far enough back to pick up a round. Needs another 1/4 inch or better rear movement to do that. That was why the pistol was disassembled to begin with. The breach block hits the lower receiver solidly while going back. The caliber is .380. What the heck is wrong?

12-10-2019, 03:43 AM	#1
Major Tom User Join Date: Jan 2017 Location: S.E. Iowa Posts: 481 Thanks: 531 Thanked 226 Times in 123 Posts	More advice needed on Erma KGP68A With help from a member here, I got this pistol assembled. The original problem was that a round would not chamber because the breach block did not go far enough back to pick up a round. Needs another 1/4 inch or better rear movement to do that. That was why the pistol was disassembled to begin with. The breach block hits the lower receiver solidly while going back. The caliber is .380. What the heck is wrong? __________________ I Build Custom Pistol Boxes