LugerForum Discussion Forums - View Single Post

sheepherder · 04-16-2014, 08:09 PM

I had an eBay vendor renege on a sale, so I had to hunt down some parts I need elsewhere...I'm waiting for parts from three eBay/GB vendors, a Brownell's order, a Numrich order, and a Travers tooling order. Backorders galore!

I managed to get the front sight dovetail cut, and milled the 'scallops' for the rear sight. Not quite like the Luger artillery, but 'good enough'...

Next I need to drill out the Luger rear sight blade & base for an inch pin (no Metric available) and drill a dimple for the re-drilled base setscrew (inch again, no Metric available).

For all practical purposes, the barrel itself is done. I do need to mill a front sight blade and press it in place, and then mill it to shape. That will come next.

04-16-2014, 08:09 PM	#12
sheepherder Lifer Lifetime Forum Patron Join Date: Feb 2009 Location: ...on the 'ol Erie Canal... Posts: 8,181 Thanks: 1,398 Thanked 4,438 Times in 2,327 Posts	I had an eBay vendor renege on a sale, so I had to hunt down some parts I need elsewhere...I'm waiting for parts from three eBay/GB vendors, a Brownell's order, a Numrich order, and a Travers tooling order. Backorders galore! I managed to get the front sight dovetail cut, and milled the 'scallops' for the rear sight. Not quite like the Luger artillery, but 'good enough'... Next I need to drill out the Luger rear sight blade & base for an inch pin (no Metric available) and drill a dimple for the re-drilled base setscrew (inch again, no Metric available). For all practical purposes, the barrel itself is done. I do need to mill a front sight blade and press it in place, and then mill it to shape. That will come next. Attached Thumbnails __________________ I like my coffee the way I like my women... ...Cold and bitter...