View Single Post
Unread 09-18-2022, 08:16 AM   #14
Deputywood
User
 
Join Date: Apr 2022
Posts: 70
Thanks: 70
Thanked 81 Times in 34 Posts
Default

I replaced my firing pin and bolt stop with new made ones available from several sources, such as Ebay and Sarco. The bolt stop required minor hand fitting. The firing pin fit without any problem. I also replaced the coil springs with replacements obtained from Wolff Springs. So far, I have experienced two breakages after many hundreds of rounds. The sight elevator detent broke under recoil. That little part was hard to find. I eventually found one at Hoosier Gun Works. The other part was the hammer pin. This pin also has the disconnector spring. The tip of the spring that lays against the disconnector broke off. A new made replacement was obtained and fitted without any issue. If you play with old guns parts will break.

Woody
Deputywood is offline   Reply With Quote