LugerForum Discussion Forums - View Single Post - Shoulder set-back .30 Luger

mrerick · 12-08-2019, 05:07 PM

Perhaps the case needs full length sizing dies? Does the brass need trimming after the first resizing? If the brass was properly sized, is there dirt in the Luger's chamber?

Crimp should not normally change OAL unless the die is set to push down too far.

Measure OAL, and Mouth to Case Head distance on reloaded cartridges. I have a standardized chamber gauge tool for testing every cartridge I reload.

12-08-2019, 05:07 PM	#2
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,900 Thanks: 1,370 Thanked 3,094 Times in 1,503 Posts	Perhaps the case needs full length sizing dies? Does the brass need trimming after the first resizing? If the brass was properly sized, is there dirt in the Luger's chamber? Crimp should not normally change OAL unless the die is set to push down too far. Measure OAL, and Mouth to Case Head distance on reloaded cartridges. I have a standardized chamber gauge tool for testing every cartridge I reload. __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.