View Single Post
Unread 01-05-2021, 06:33 PM   #12
Doubs
User
 
Doubs's Avatar
 
Join Date: Jun 2002
Location: Byron, Georgia
Posts: 1,663
Thanks: 762
Thanked 1,588 Times in 518 Posts
Default

Quote:
Originally Posted by lugerholsterrepair View Post
So..resizing as a last step doesn't mar the outside case walls with your method?
Resizing takes place in the press first step. With the cases as clean as new, I think it protects both brass and dies from damage that grit and dirt may cause.

I have an old RCBS 4X4 semi-progressive press with four die stations. The disc must be turned manually to advance the cases.. Also manual is the primer feed and the powder measure throw.

First station sizes the brass and de-caps if not already. Second station bells the case mouth and seats a primer on the down stroke. Third station drops the powder and fourth station seats the bullet. Later I use a single stage press to taper crimp.

A light is positioned so that the powder charge can be verified before seating the bullet.

It's not as fast as a full progressive press but it's built like a tank and works very well.
Doubs is offline   Reply With Quote
The following 2 members says Thank You to Doubs for your post: