LugerForum Discussion Forums - View Single Post

ViggoG · 07-27-2001, 01:54 AM

My $.02 ;

The matter of indexing the barrels would seem to be a fairly simple problem .

The barrel (part 002) could be finished up to the point of milling the front sight post .

At this point it would be screwed into a "Holding Fixture" that has the exact thread dimensions as the "Standard Fork"(part 017) which positions it for the sight post machining secquences .( such fixture being mounted on a milling machine with the proper tooling to form the sight post ).

No magic involved and all barrels are precisely the same .

Perhaps it was done this way, or perhaps any one of several other ways. There are numerous possibilities ..

Just a thought to give some insight on the possibilities that may be involved .

ViggoG

07-27-2001, 01:54 AM	#4
ViggoG RIP Join Date: Jun 2002 Location: South Side Virginia Posts: 534 Thanks: 0 Thanked 1 Time in 1 Post	Re: Barrel indexing "Possibility" My $.02 ; The matter of indexing the barrels would seem to be a fairly simple problem . The barrel (part 002) could be finished up to the point of milling the front sight post . At this point it would be screwed into a "Holding Fixture" that has the exact thread dimensions as the "Standard Fork"(part 017) which positions it for the sight post machining secquences .( such fixture being mounted on a milling machine with the proper tooling to form the sight post ). No magic involved and all barrels are precisely the same . Perhaps it was done this way, or perhaps any one of several other ways. There are numerous possibilities .. Just a thought to give some insight on the possibilities that may be involved . ViggoG