LugerForum Discussion Forums - View Single Post

lugerholsterrepair · 12-16-2005, 05:40 PM

Herb did me the courtesy of sending me a photo. This is a reproduction . The brass closure assembly's used on original Dutch holsters are very small and quite difficult to make. The tiney rivets must be hand hammered on. These would not be economically feasable to replicate. Hence the steel stud closure on this repro. Jerry Burney

12-16-2005, 05:40 PM	#10
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Herb did me the courtesy of sending me a photo. This is a reproduction . The brass closure assembly's used on original Dutch holsters are very small and quite difficult to make. The tiney rivets must be hand hammered on. These would not be economically feasable to replicate. Hence the steel stud closure on this repro. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."