LugerForum Discussion Forums - View Single Post - Safety Issue

jamese · 06-17-2005, 08:12 AM

Rick,
I also agree with John. The factory size is 5.0 mm. If its out of round say only a small amount. I think I have some oversized pins that can fit. Have it drilled out round again at a michine shop. ( I'm sure it can't cost that much)

I have the following oversize pins;

.05
.1
.15
.2

how far is it out of round ? if is out of round more than .2, you may be right that the part can't be used. But before you give up on it check with a michine shop.

Jim

06-17-2005, 08:12 AM	#17
jamese User Join Date: Jan 2003 Location: South Florida Posts: 792 Thanks: 0 Thanked 86 Times in 36 Posts	Rick, I also agree with John. The factory size is 5.0 mm. If its out of round say only a small amount. I think I have some oversized pins that can fit. Have it drilled out round again at a michine shop. ( I'm sure it can't cost that much) I have the following oversize pins; .05 .1 .15 .2 how far is it out of round ? if is out of round more than .2, you may be right that the part can't be used. But before you give up on it check with a michine shop. Jim __________________ The "truth" is a matter of Perception