LugerForum Discussion Forums - View Single Post - Progress Report! Off the saw & on to the shaper!

G.T. · 06-07-2001, 07:59 AM

Hi Tom! You sure got that right! I work on them in small increments of time.....when the sweat starts pouring off me, I stop for awhile and get out of the heat....a drop of sweat on an unfinished mag. bottom makes the grain stand up so bad, it is almost unsalvageable!! Some day, when my ship comes in, (I think it did once, but someone else unloaded it!) I will air condition my garage....or build a small shop, a shop filled with woodworking equipment & Luger stuff! That would be about the top of the mountain for me!!! till....later....G.T.

06-07-2001, 07:59 AM	#7
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,525 Thanks: 1,321 Thanked 3,709 Times in 1,013 Posts	Re: Progress Report! Off the saw & on to the shaper! Hi Tom! You sure got that right! I work on them in small increments of time.....when the sweat starts pouring off me, I stop for awhile and get out of the heat....a drop of sweat on an unfinished mag. bottom makes the grain stand up so bad, it is almost unsalvageable!! Some day, when my ship comes in, (I think it did once, but someone else unloaded it!) I will air condition my garage....or build a small shop, a shop filled with woodworking equipment & Luger stuff! That would be about the top of the mountain for me!!! till....later....G.T.