LugerForum Discussion Forums - View Single Post - The Dok needs help! (No smart comments... <IMG SRC="/luger/graphics/wink.gif" BORDER=0 ALT=";)"> )

Frank · 06-06-2001, 04:18 PM

The small loop cleaning rod is made of 0.216 inch rod. The handle loop inside diameter is 0.229 in.. The outside should measure 0.661 in,, but mine is 0.669 in.. The handle width is 1.680 in. over-all. The over-all length is 5.4 in. The screw thread starts about 2.25 in. above the brass tip. Let me know if I can give you more. See, no SA (this time)

06-06-2001, 04:18 PM	#3
Frank RIP Patron LugerForum Patron Join Date: Jun 2002 Location: Hot & Dry PHX, AZ Posts: 2,078 Thanks: 24 Thanked 165 Times in 87 Posts	Okey Dokey Dok !! No Smart Remarks !!! The small loop cleaning rod is made of 0.216 inch rod. The handle loop inside diameter is 0.229 in.. The outside should measure 0.661 in,, but mine is 0.669 in.. The handle width is 1.680 in. over-all. The over-all length is 5.4 in. The screw thread starts about 2.25 in. above the brass tip. Let me know if I can give you more. See, no SA (this time)