LugerForum Discussion Forums - View Single Post - P08 Disassembly Problem <IMG SRC="/luger/graphics/frown.gif" BORDER=0 ALT=":(">

Robert Wiggins · 06-03-2001, 01:16 PM

AH HA! I've done it!!!

NO, I didn't put the screw driver through my hand!

Did as suggested, with a little modification of my own.

Lifted the leading adge of the spring to clear the detent of the bar; slipped a fine jewelers screwdriver under the lip of the spring resting between the bar and the spring; Then placed a similar screwdriver against the leading edge of the spring and slid it out of the groove no problem. It was very easy....in this particular case.

Thanks again folks, god this site is better than a book!

06-03-2001, 01:16 PM	#8
Robert Wiggins User Join Date: Jul 2002 Location: Toronto, Ontario, Canada Posts: 142 Thanks: 16 Thanked 0 Times in 0 Posts	Re: P08 Disassembly Problem AH HA! I've done it!!! NO, I didn't put the screw driver through my hand! Did as suggested, with a little modification of my own. Lifted the leading adge of the spring to clear the detent of the bar; slipped a fine jewelers screwdriver under the lip of the spring resting between the bar and the spring; Then placed a similar screwdriver against the leading edge of the spring and slid it out of the groove no problem. It was very easy....in this particular case. Thanks again folks, god this site is better than a book!