LugerForum Discussion Forums - View Single Post - P08 Disassembly Problem <IMG SRC="/luger/graphics/frown.gif" BORDER=0 ALT=":(">

John D. · 06-03-2001, 01:14 PM

Hi Robert....

FIRST - cover the side of the reciever (spring side) with a few layers of masking tape (in case the screwdriver slips!!!). Next a small jewelers screwdriver will fit under the "lip" of that spring.

Lift the leading edge of that spring enough to clear the detent in the bar...

Then push it forward (this is when the screwdriver typically SLIPS - scratching the reciever and poking a bloody hole in the palm of your other hand that is holding the reciever - so BE CAREFUL )

It will slide forward in the groves and release... From there - you can proceed to step 13....

06-03-2001, 01:14 PM	#2
John D. Administrator & Site Owner LugerForum Patron Join Date: Jun 2002 Location: A Little NE of Somewhere... Posts: 2,651 Thanks: 478 Thanked 517 Times in 129 Posts	Re: P08 Disassembly Problem Hi Robert.... FIRST - cover the side of the reciever (spring side) with a few layers of masking tape (in case the screwdriver slips!!!). Next a small jewelers screwdriver will fit under the "lip" of that spring. Lift the leading edge of that spring enough to clear the detent in the bar... Then push it forward (this is when the screwdriver typically SLIPS - scratching the reciever and poking a bloody hole in the palm of your other hand that is holding the reciever - so BE CAREFUL ) It will slide forward in the groves and release... From there - you can proceed to step 13....