LugerForum Discussion Forums - View Single Post

Thor · 05-21-2001, 08:14 PM

The firing pin should be very lightly lubricated, at the front side and back side areas. The vents in the front are so the pin will hit hard (some say for gas blow back if the case fails) if too much grease is in the breech block firing pin "tunnel" a little is preferred to a lot! BIS SPAETER! ~ Thorboy~

05-21-2001, 08:14 PM	#12
Thor User Join Date: Jun 2002 Location: Rio Rancho, New Mexico Posts: 4,583 Thanks: 958 Thanked 971 Times in 277 Posts	Re: A Question of Lubricants The firing pin should be very lightly lubricated, at the front side and back side areas. The vents in the front are so the pin will hit hard (some say for gas blow back if the case fails) if too much grease is in the breech block firing pin "tunnel" a little is preferred to a lot! BIS SPAETER! ~ Thorboy~