LugerForum Discussion Forums - View Single Post

Pete Ebbink · 06-13-2004, 11:42 AM

Here is the reply that Craig received from "Guisan" on the Swiss gun site :

" It is pretty easy to get both out, this is from the armourer's manual;

Safety lever
Taking apart
sliding out downward while in safe position.

Fitting
fitting the part from below and switch to safe position.

Grip safety
Taking apart
Take off both grips. Press the "wing" of the safety lever towards the frame. Lift out the notch from its hole and take off the grip safety.
Take off grip safety spring.

Fitting
Fit grip safety spring.
First put the grip safety under the safety lever, then slide upward and enter the notch in its hole.
Pay attention to the position of the grip safety which must be partly over the grip safety spring.
Check functioning.
Fit grips.

Thanks,
Guisan. "

06-13-2004, 11:42 AM	#7
Pete Ebbink User Join Date: Jun 2002 Location: The USA Posts: 5,919 Thanks: 0 Thanked 6 Times in 4 Posts	Here is the reply that Craig received from "Guisan" on the Swiss gun site : " It is pretty easy to get both out, this is from the armourer's manual; Safety lever Taking apart sliding out downward while in safe position. Fitting fitting the part from below and switch to safe position. Grip safety Taking apart Take off both grips. Press the "wing" of the safety lever towards the frame. Lift out the notch from its hole and take off the grip safety. Take off grip safety spring. Fitting Fit grip safety spring. First put the grip safety under the safety lever, then slide upward and enter the notch in its hole. Pay attention to the position of the grip safety which must be partly over the grip safety spring. Check functioning. Fit grips. Thanks, Guisan. "