LugerForum Discussion Forums - View Single Post

policeluger · 05-20-2003, 06:14 PM

I have re-barreled a few Lugers with Gun Parts Inc barrels. As too where these barrels are made it is anyones guess, none have an import mark that I have seen, however all fitted well, but all needed a bit taken off the shoulder too line the front sight up, and I recut each chamber too headspace. As best I can describe, they are a bit better in the chambers then some of the East German imports I had here that would not even chamber a round until recut.

05-20-2003, 06:14 PM	#3
policeluger RIP Join Date: Jun 2002 Location: Ca. Posts: 2,141 Thanks: 8 Thanked 89 Times in 54 Posts	I have re-barreled a few Lugers with Gun Parts Inc barrels. As too where these barrels are made it is anyones guess, none have an import mark that I have seen, however all fitted well, but all needed a bit taken off the shoulder too line the front sight up, and I recut each chamber too headspace. As best I can describe, they are a bit better in the chambers then some of the East German imports I had here that would not even chamber a round until recut.