Hello John,
If you do not get a reply, you might want to take this piece to the Tulsa gun show in October.
Lots of luger folks there (including a few Forum members) with tables that could help you and maybe do an assessment as well.
I would recommend looking up Mr. Tom Heller (known as "LugerDoc" here on the Forum). The show folks have a locator service table. Look up a fellow's name, and the table location is given...which is very helpful since the show normally has over 3800 tables...
Here is the Tulsa gun show link :
http://www.tulsaarmsshow.com/frames.html
Also, you might try going to the "Technical Information" section of the Luger Forum. There is a Parts & Disassembly guide...that is most helpful...you might want to give her a try, yourself...
Tip : When reassembling the gun, which is the reverse of step # 8 shown, hold the receiver/frame upside-down...this makes getting the S-shaped toggle link (part # 009 in the exploded-view drawing) to fall in place, easier...
Regards,
Pete... <img border="0" alt="[typing]" title="" src="graemlins/yltype.gif" />